UD IMP RDA Rebuildable Dripping Atomizer, has three posts with 2.5mm post hole. It also comes with wide bore drip tip with spral groove for large vape, ceramic base and airflow adjustable through base.
UD IMP RDA
UD IMP RDA Rebuildable Dripping Atomizer, has three posts with 2.5mm post hole. It also comes with wide bore drip tip with spral groove for large vape, ceramic base and airflow adjustable through base. A low height and precise RDA for you! Try it to enjoy vaping fun.
Diameter: 22 mm
Height with top cap: 29mm
Height with wire drip tip: 40mm
Oil Capacity： Dripping
Connection： 510 thread
UD IMP RDA atomizer comes with
Simple packing. Customary Packing from the factory, the packing is subject to change without notice.
1. two negative posts and one positive post with 2.5mm post hole
2. wide bore drip tip with spiral groove
3. ceramic base
4. airflow adjustable through base
1. Prepare scissors, screwdriver, tweezers before beginning.
2. Unpack the accessory bad and wrap the wire to the wick.
3. Disassemble the base pedestal from the tank.
4. Take one wire made in step 2, one end connected to hole a (from left to right, a, b, c post), and tighten up the screw, the other end to post b; take the second wire made in step 2, opposite, one end connected to the hold c and tighten up the screw, the other end to hole b, then tighten up the screw in hole b; Connect the MOD for short circuit test.
5. Cut extra wires, well wrap the wick, inject oil, assemble the top cap or drip tip, and properly adjust the air flow by turning the connecting tube, then to vape.
6. To use a small drip tip, please the wide drip tip with the top cap.
7. Connect the atomizer to the MOD and enjoy vaping.
Note: do not inject too much or too less liquid.
No Customer Review
Questions and answers about this item.Ask a Question