60W Innokin iTaste MVP3.0 Pro VV/VW Express Kit


Product Introduction

60W Innokin iTaste MVP3.0 Pro VV/VW Express Kit is the newest highly powered vaporizer. With perfect size and clean lines, the iTaste MVP3.0 Pro features high compatibility 510 connector, can work with all standard 510 clearomizers & atomizers including the iClear 16, iClear 16B, iClear 16D, iClear 30, iClear 30B, iClear 30S and the iSub Tanks.


Parameters of MVP3.0 Pro MOD

Operating Voltage: 3.0V - 9.0V

Operating Wattage: 6.0W - 60W

Battery Capacity: 4500mAh

Operating Resistance: 0.2ohm - 0.5ohm

Charger Port: Micro USB


Parameters of iSub Tank Cartomizer

Airflow Adjustable

Resistance: 0.5ohm

Recommended Wattage: 20W - 35W


It comes with

  • 1 x 60W Innokin iTaste MVP3.0 Pro VV/VW MOD
  • 1 x 510-eGo Adapter
  • 1 x USB Cable
  • 1 x MPV3.0 Pro Manual
  • 1x Innokin Sticker

Simple packing. Customary packing from the factory, the packing is subject to change without notice.


Features

1. 15 seconds cut-off

2. Flip OLED Screen Orientation

3. Low Voltage Warning

4. Short Circuit/ Atomizer Protection

5. Overheat Protection

6. Over-discharge Protection

7. Pass-through Function

8. Remembers Last Voltage or Wattage setting

9. Portable power source for electronic products


How To Use the MOD

1. Press "Power Button" three times to turn on the device.

2. The LED light on the top will blink to display the current battery level. Green indicates the battery is almost fully charged. The LED light will power off when it's fully charged. Yellow means around half power left, while Red means low power, you need to get the device charged.

3. When the power button is pressed, the OLED screen will display the attached atomizer resistance, voltage, wattage and remaining battery level.

4. Hold on both "+" and "-" buttons simultaneously, the screen will display: resistance of atomizer, battery voltage, puffs taken since the device was last turned off and the last set voltage or wattage.

5. Press both "+" and power button to enter variable wattage mode. Click "+" or "-" to adjust the wattage by 0.1 wattage.

6. Press both "-" and power button to enter variable voltage. Click "+" or "-" to adjust the voltage by 0.1 voltage.


60W Innokin iTaste MVP3.0 Pro Express Kit - 4500mAh


How to Fill the Cartomizer

1. Carefully unscrew the metal section.

2. Add e-liquid against the inside wall of the tank.

3. Carefully and firmly tighten. Do not overfill.

4. Prepare coils by adding 2-3 drops e-juice to the center wicks. Wait 1 minute before vaping.


How to Replace Coils

1. Unscrew the top section of the metal cap.

2. Gently hold and pull the coil out.

3. Align the flat sides of a new coil.

4. Push and insert the new coil to tank.

5. Carefully and firmly tighten the metal cap.


60W Innokin iTaste MVP3.0 Pro Express Kit - 4500mAh


  • There is CE mark on the package.
  • No e-juice included. You have to buy it here.
  • Replacement coils is available.



3 months
Pls check guarantee policy.