Register and sign in your account to get bulk discounts!
The itaste SVD (Superior Vaping Device) is a tube style, variable voltage, variable wattage Electronic Cigarette, made of Stainless Steel. The iTaste SVD is sleek, with easy to use functionality.
Variable Voltage: voltage can be adjusted from 3.3 – 6.0 volts in .1 volt increments.
Variable Wattage: Wattage can be adjusted from 3.0 – 15.0 W in .5 watts increments.
Short Circuit Protection.
Reverse Battery Protection Circuit
Battery Voltage Detection
Resistive Load Detection ( Ohms meter )
ON/OFF battery switch
LED Battery Power Display
Low Voltage Warning
Overtime Vaping Warning
Telescopic tube supports 18350, 18650 batteries
Battery safety protection
Myriad compatible ( eGo thread )
Change battery and switch VV or VW have parameter memory function
Built-in 3 digit display ( Ohms meter , Volts /Watts , Atomizer voltage output )
Innokin iTaste SVD VV/VW MOD only comes with 1x iTaste SVD and 1x Telescopic tube, Telescopic tube supports 18350, 18650 batteries
It comes with a standard eGo connector, so it is compatible with 510/eGo/eGo-T/eGo-C products.
It doesn't come with e-liquid, you should order separately.
iTaste SVD * 1PC
Telescopic tube * 1PC
Dimension: 111mm *Φ23.5mm
Maximum Current Output: 5.0 Amperage
Operating Voltage: 3.3V-6.0V
Operating Wattage: 3.0W-15.0W
|Guarantee(Please check Guarantee Policy)|
|Guarantee period: 3 months for Innokin itaste SVD VV/VW MOD battery body without telescopic tube|
1. Battery Installation
Telescopic tube supports 18350, 18650 batteries.
2. When battery installed and circuit connected, the LED light will enter a blinking cycle from red, yellow to green and the digital display will show 888, then show the previous parameter setting, and then will be in off mod.
3. Quickly clicking the power button three times will enable or disable the battery, once enabled, holding down the button will activate the battery.
4. Holding the power button and “-“ button simultaneously for 3 seconds to enter voltage status, then you can adjust the voltage by pressing “+” “-“ button.
5. Holding the power button and “+“ button simultaneously for 3 seconds to enter Wattage status, then you can adjust the voltage by pressing “+” “-“ button.
6. Holding “+” and “-“ button simultaneously for 2 seconds, the digit screen will display the load ohms, the load ohms range will be 0-9.9ohm.
7. Hold both the + and – buttons for five seconds to Lock the selected Voltage or Wattage
|Simple paper box. Customary Packing from the factory,the packing is subject to change without notice.|