Joyetech eGo One CLR Atomizer Head 5pcs
5pcs Joyetech eGo One CLR Atomizer Head is the specially designed atomizer head for Joyetech eGo One. With CLR head, you’re able to rebuild it while performance diminishing. Get it to enjoy vape and DIY fun!
- 100% Quality Guarantee
- 24 hours delivery
- 7 Days Money Back Guarantee
You may mix the following items to get bulk discount.
USD 9.90 USD 14.85
USD 2.35 USD 3.00
USD 3.80 USD 5.00
USD 8.20 USD 12.30
USD 1.08 USD 2.00
USD 0.13 USD 0.19
USD 2.35 USD 4.00
USD 4.60 USD 6.90
USD 8.20 USD 12.30
USD 2.75 USD 3.40
1. Joyetech now requires S/N (serial number) before providing replacements (due to counterfeits in market). We recommend you to keep the packing boxes after you get parcel, or take a picture of SN before you discard it. Thank you!
2. Shipping restriction: Due to exclusive distributor of Joyetech, we do not send Joyetech products to customers in Russia, South Korea or UK. You can check more exclusive distributors .
5pcs Joyetech eGo One CLR Atomizer Head
Product introduction5pcs Joyetech eGo One CLR Atomizer Head is the specially designed atomizer head for Joyetech eGo One. With CLR head, you’re able to rebuild it while performance diminishing. Get it to enjoy vape and DIY fun!
Pre-made coil resistance: 1.0ohm, 0.5ohm
Pre-made coil diameter: 0.4mm
Suggested coil resistance: more than 0.3ohm
- 1 x 5pcs Joyetech eGo One CLR Atomizer Head
1.Prepare the heating wire. Standard heating wire for example. Take a piece of heating wire of around 60millimeters long and roll the heating wire; Reserve around 8.5mm on one side, and then rotate 5 - 6 circles reserving around 7mm on the other side. Bend a little at bot ends.
2.Install the regulating ring to the atomizer tube and screw it tightly. This ring could adjust the amount of liquid entering.
3.Put the heating wire into the tube, and keep it in the center position.
4.Put the long end into notch, pass the short end through the insulating ring.
5.Install the insulating ring and connection base to the tube.
6.Adjust the position of the heating wire and make the cotton cross the heating coil, cut off the redundant cotton to keep flush with liquid entering notches.
7.Screw on the top cap tightly.
Remark: please drip a few drops of e-juice on the cotton and make sure it is moist before the first use, or it will burn.
- It’s only suitable for Joyetech eGo One.
Share your thoughts with other customersWrite a Review
Typical questions asked about products:
- Is the item durable?
- Is this item easy to use?
- What are the dimensions of this item?