SMOK TF-RDTA S2 Deck

Product Introduction

SMOK TF-RDTA S2 Deck, is the deck for SMOK TF-RDTA tank. Get it as a spare part!


Parameters

Color: Steel
Style: Dual-Post Velocity
diameter: 16mm
Wire: 0.2ohm Dual Clapton wires (Pre-installed)


S2 Deck comes with

  • 1 x TF-RDTA S2 Deck
  • 1 x allen key
  • 4 x Replacement screws
  • 2 x Sealing Rings


Simple packing. Customary packing from the factory, the packing is subject to change without notice.

SMOK TF-RDTA S2 Deck

SMOK TF-RDTA S2 Deck

HOW TO BUILD THE RDTA(S2)
1. Before starting make sure your hands are clean.
2. Taking the TF-RDTA S2 deck apart.
3. Installing the pre-wrapped coil. Insert one end of your coil into the left-side holes, and the other end into the right-side holes.
4. Positioning and cutting the exceeding ends of wire off.
Make sure the coil is fixed and lined up with the air hole, and also make sure the coil is NOT touching the deck. Then cut the exceeding ends of wire off.
5. Cutting a strip of cotton and make sure it’s just larger than the coil you built.
6. Inserting the cotton, and placing it in the middle.
7. Then guide the ends of cotton wick through the holes below.
8. Cutting the ends and make sure it’s not too short and not too long.
9. Wet the coil with your e-liquid and adjust the wick.
Warning: Coils must be checked for resistance before they are fired on a device, and re-checked periodically to ensure the resistance remains the same.


SMOK TF-RDTA S2 Deck