SMOK TF-RTA G4 Deck

Product Introduction

SMOK TF-RTA Deck, G2 Deck and G4 Deck, are spare parts for SMOK TF-RTA Tank. One is quad-coil G4 Deck and the other with dual-post velocity G2 Deck.


Parameters

Color: Steel
Type: G4 and G2 Deck


G4 Deck comes with

  • 1 x TF-RTA G4 Deck
  • 1 x Cross point screwdriver
  • 2 x Replacement screws
  • 2 x Sealing Rings

SMOK TF-RTA G4 / G2 Deck

G2 Deck comes with

  • 1 x TF-RTA G2 Deck
  • 1 x Allen Key screwdriver
  • 2 x Replacement screws
  • 2 x Sealing Rings

SMOK TF-RTA G4 / G2 Deck


Simple packing. Customary packing from the factory, the packing is subject to change without notice.

SMOK TF-RTA G4 / G2 Deck

How to build the G4 Deck:
1. Before starting make sure your hands are clean.
2. Taking the TF-RTA G4 deck apart.
3. Installing the pre-wrapped coil. Insert one end of your coil into the up-side screw, and the other end into the down-side screw.
4. Positioning and cutting the exceeding ends of wire off. Make sure the coil is fixed and lined up with the air hole, and also make sure the coil is NOT touching the deck.
Then cut the exceeding ends of wire off.
5. Cutting a strip of cotton and make sure it's just larger than the coil you built.
6. Inserting the cotton, and placing it in the middle.
7. Cutting the wick at an angle and make sure it's not too short and not too long.
8. Wet the coil with your e-liquid and adjust the wick.
Warning: Coils must be checked for resistance before they are fired on a device, and re-checked periodically to ensure the resistance remains the same.


How to build the G2 Deck:
1. Before starting make sure your hands are clean.
2. Taking the TF-RTA G2 deck apart.
3. Installing the pre-wrapped coil. Insert one end of your coil into the left-side holes, and the other end into the right-side holes.
4. Positioning and cutting the exceeding ends of wire off. Make sure the coil is fixed and lined up with the air hole, and also make sure the coil is NOT touching the deck.
Then cut the exceeding ends of wire off.
5. Cutting a strip of cotton and make sure it’s just larger than the coil you built.
6. Inserting the cotton, and placing it in the middle.
7. Cutting the wick at an angle and make sure it’s not too short and not too long.
8. Wet the coil with your e-liquid and adjust the wick.
Warning: Coils must be checked for resistance before they are fired on a device, and re-checked periodically to ensure the resistance remains the same.

SMOK TF-RTA G4 / G2 Deck


SMOK TF-RTA G4 / G2 Deck


Our images are copyrighted. It is forbidden to reprint without our permission.

SMOK TF-RTA G4 / G2 Deck