Joyetech eVic Basic TC MOD - 1500mAh

Product Introduction

Joye eVic Basic TC MOD comes with max 40W output &1500mAh battery capacity, which features compact size, RTC & custom logo function, dual battery protection and upgradeable firmware. 4 colors for your selection.


Size: 22 x 32 x 55 mm
Battery capacity: 1500mAh
Output mode: RTC/VW/VT(Ni/Ti/SS316)/Bypass/TCR
Output wattage: 1- 60W (with Firmware V4.14)
Temp range: 100 - 315℃(200 - 600F)
Resistance range: 0.05 - 1.5ohm for VT/TCR modes; 0.1 - 3.5ohm for VW/BYPASS modes

It comes with

  • 1 x eVic basic Mod Battery
  • 1 x USB Cable
  • 1 x Manual
  • 1 x Warning card

Simple packing. Customary Packing from the factory, the packing is subject to change without notice.

Ultimate compact with intuitive design

Supports RTC/ VW/VT/ BYPASS /TCR Mode

Real time clock & Custom logo function
Dual circuit protection and upgradable firmware

Power on and off: Press the fire button 5 times in quick succession, the screen will on. Then it's ready to use. In the same way, the device will be turned off by pressing another 5 times in quick succession.

Vaping: Hold the fire button and inhale the mouthpiece. Release the fire button and exhale.

Charging and upgrading: Simply connect the device with a micro USB cable to charge or upgrade. When it's fully charged, the display will go out.

Set screen protection: When the device is on, simultaneously hold the fire button and the right regulatory button to enter into adjustment interface. Press the right button again to enter into screen protection time setting. Choose the protection time and press the fire button to confirm.

Reset: Should you get stuck while upgrade, just press the "+" button and then insert into the reset hole with a needle to restart.

Switch among different modes: Press the fire button 3 times to enter into the setting menu. Press the right regulatory button to switch among TEMP, TCR, Power and BYPASS modes. Press the fire button to confirm. And press left button while flashing to enter into subsidiary menu.

How to set the TCR: In power-off condition, press the fire button and right regulator simultaneously for about 5 seconds to enter into TCR set menu:

1. Press right/left regulator to choose between TCR M1, M2, M3;
2. Then press the fire button to select certain parameter;
3. Press the regulator to set the parameter;
4. Long press the fire button or leave it for about 10 seconds to confirm.

3 months of eVic Basic TC MOD. Please check Guarantee Policy.

Note: We now need serial number to proceed after-sales service. Please kindly preserve the serial number of product if it's available.